Audi 80/Avant
- The description
Engines
Transmissions
Body
The chassis
15-inch wheels
Brake system
Seats
Passive safety
Full drive
Distributive Torsen-differential
Dynamics of movement at a dry road covering
Instructions on operation for all-wheel drive cars
Blocking of differential of the back bridge
Motor compartment
Regular servicing
The workplace organisation
Lubricant works
The oil expense
Correct choice of engine oil
Replacement of engine oil and the oil filter
Check of level of a working liquid of the amplifier of a wheel
Check of level of oil of a mechanical transmission
Check of level of oil in a drive of the back bridge
The control of level ATF in an automatic transmission
Check of level of oil in the main transfer of an automatic transmission
Replacement ATF
Greasing тросовых drives, hinges and locks
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
+ Injection system
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
+ Kuzovnaja electrosystem
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications
|
Replacement of engine oil and the oil filter
|
|
The carving stopper маслосливного can be got apertures only after removal of the bottom protection of a motor compartment. For untwisting is better will approach накидной a key. |
|
|
Thus the oil filter (1) by means of a key-collar (2) is turned off. On an illustration the filter of the 4-cylinder engine is shown. |
|
|
- Oil needs to be changed only on the heated-up engine! If necessary it is possible to be passed a little to warm up the motor.
- Car Audi 80 whenever possible to lift and fix horizontally (on support!) or to tyre out on a platform.
- To remove the bottom protection of a motor compartment, see the head about a body.
- To substitute under the oil pallet a suitable vessel.
- To open a carving stopper маслосливного apertures a ring key. To allow to oil to flow down. Cautiously, it is hot!
- If you have raised the car only in front for the fulfilled oil full plum it is necessary to lower the car once again. Watch, that thus the capacity with the fulfilled oil has not been damaged or overturned.
- To substitute capacity for the fulfilled oil under the oil filter.
- To turn away the oil filter by means of a key-collar. At very dense the sitting filter to punch a screw-driver a filter wall (it is cautious, follows hot oil) and to scroll the filter.
- Slightly to grease with plastic greasing a sealing ring on the new oil filter. Not to apply for this purpose oil because at its visual control it is easily erroneous to accept for following oil.
- To wrap the oil filter a hand without application of any tools.
- To wipe dry and absolutely carving stopper маслозаливной mouths and to screw it with a new sealing ring; cautiously, not to damage directing carving in the oil pallet.
- To fill in oil (see the table).
- To get the engine, to check up oil on вытекание.
|
|
Quantity of oil
|
Engine oil
|
The 4-cylinder engine
|
The 5-cylinder engine
|
The 6-cylinder engine
|
| Quantity of oil without replacement фильтра* |
2,5 l |
3,5 l |
4,5 l |
| Quantity of oil with filter replacement |
3,0 l
|
4,0 l |
5,0 l |
* Only at oil replacement between recommended intervals
|
On the main page
|