Audi A3

Since 1997 of release

Repair and car operation


Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
- Manual box of a gear change
   Removal and installation РКПП
   Gear change drive
   Removal and installation of the case of the mechanism of a choice of transfers
   Adjustment of a drive of switching
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes

Gear change drive
THE GENERAL DATA

Traction drive of a gear change. Engines of 1.6 l
And – draughts of switching
In – draught of a choice of transfer		 Arrow And transfer switching
Arrow In moving of a choice of transfer

Trosovyj drive of a gear change. Engines of 1.8 l
And – draughts of switching
In – draught of a choice of transfer
With – the heat-shielding screen of system of release
Acts in film before removal of a drive of switching		 1 – the gear change lever
2 – the directing lever with capture/cable
Arrow And transfer switching
Arrow In moving of a choice of transfer

At transfer inclusion it is necessary to do distinction between cross-section moving (a transfer choice) switching lever in neutral position and actually transfer switching. Both movings at the car with the engine of 1.6 l are transferred on РКПП through draughts.

With engines of 1.8 l for transfer of movings of the lever of gear changes instead of draughts are available for models two cables.
After removal РКПП or dismantling of a drive of its switching it is necessary to adjust again.
ATTENTION

All support and friction surfaces to grease with greasing AUDI G 052 142 A2.
All support and friction surfaces to grease with greasing AUDI G 052 142 A2.
On the main page