| 1. Establish the selector in position “Р”. |
|
2. Turn away a bolt–2 at a forward support–1 cables of the selector. |
3. Establish the selector–4 in position “Р”, having pressed it to a back emphasis. Parking blocking should be fixed, at the released lay brake the car should not move.
ATTENTION Do not remove lock скобу.
|
| 4. Displace a cable of the selector at a bolt–2 so that it has not been tense. In this position tighten a bolt–2 moment 5 Н·м. |
| 5. In summary check up adjustment by the image described more low. |
| Adjustment check |
| 6. Translate the selector in position “Р” at the pressed lock key in the handle approximately on 5 mm back and release. The selector should return to a starting position independently. |
| 7. Translate the selector in position “N” at the pressed lock key in the handle approximately on 5 mm forward and release. The selector should return to a starting position independently. |
| 8. If the selector is not fixed, repeat adjustment. |
| 9. Pass on the car and check up selector work. The engine should be started only in position of selector "É" or “N”. |
| 10. Include ignition. At the standing car the selector should have possibility to leave only from position “Р” or “N” if the brake pedal is simultaneously pressed. |
| Adjustment of a cable of blocking of switching |
| 11. Establish the selector in position “1”. |
| 12. Remove covers of a steering column. |
| 13. Turn the ignition key in position “Start” and release. Check up a backlash between the lever of a cable and a lock finger of the lock. It should make 0.7 mm. |
| 14. For adjustment ослабьте a tightening nut of a cable also arrange the lever of a cable for achievement of a demanded backlash. |
|
15. Tighten a tightening nut. |
| 16. Tighten bolts of the case of the switch and establish covers of a steering column. |
| Adjustment of an electromagnet of blocking of switching |
| 17. Establish the selector in position “N” or “Р”. |
| 18. Loosen the bolts of fastening of an electromagnet. |
|
19. Establish probe 0.3 mm between a pusher of an electromagnet and the lever. |
| 20. If it is required shift an electromagnet and tighten bolts of its fastening. |