Audi A3

Since 1997 of release

Repair and car operation



Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
- Automatic transmission and models with a full drive
   Adjustment of a cable of the selector of switching of automatic transmission
   Removal and installation of automatic transmission
   Diagnostics of electric components and reading of codes of malfunctions
   Full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes

Diagnostics of electric components and reading of codes of malfunctions

THE GENERAL DATA


The system of electronic control by transmission consists of the management block (ТСМ), located under a back seat, electromagnets of management, various gauges and gauges-switches.

If ТСМ reveals malfunctions in management chains, it bring them in memory. For reading of codes electronic tester VAG 1551 with adapter VAG 1551/3 is used.

The remark: All information on reading of codes contains in a tester.

Revealing of malfunctions is alternative can be made by measurement of values of resistance and pressure by means of tester VAG 1598/18 (Address to tables).

Check of pressure is made without switching-off of the storage battery, - the tester is connected to ТСМ and its electroconducting. At check of resistance disconnect a negative wire from the battery and connect a tester to a plait of electroconducting ТСМ. ТСМ leave disconnected.

At malfunction revealing it is necessary to make repair of electroconducting or a corresponding element of a chain.
If everything is all right, hence, it is damaged actually ТСМ.

Check of pressure and resistance for the purpose of revealing of malfunctions of electric elements

Contacts
On VAG
1598/18
The subject
To check uchas -
System current
The conditions which are subject
To performance and
Additional procedures
The nominal
Values
Actions on revealing
Causes of defect
23 + 1 Pressure
Food ТСМ
Ignition is included (a key in
Position ON)

The pressure close
To pressure of the battery
Check up a condition
The electroconducting going from
Plugs № 1
Check up on presence
Conductivity electroconducting,
Going from the plug № 23 to
To safety lock С/15А in
The assembly block
Safety locks/relays
5 + 28 The gauge
Positions
The throttle
заслонки
Ignition is switched off (a key in
Position OFF)
Throttle заслонка
It is completely closed
Throttle заслонка
It is completely open


700 + 1800 Ohm

2100 + 3900 Ohm

Check up a condition
Electroconductings

Make gauge calibration
Positions throttle заслонки

5 + 50 The gauge
Positions
The throttle
заслонки

Ignition is switched off (a key in
Position OFF)
Throttle заслонка
It is completely closed
Throttle заслонка
It is completely open


2100 + 3900 Ohm

700 + 1800 Ohm

Check up a condition
Electroconductings

Make gauge calibration
Positions throttle заслонки

29+15 The electromagnetic gauge-switch of blocking of switching Ignition is included (ON) the selector Lever in position "Р" or "N"
The foot brake is squeezed out
The pressure close to pressure of the battery
Nearby 0.2 In
Check up electroconducting
Replace an electromagnet of blocking of switching
15+1 Signal from the gauge-switch of stoplights Ignition is included (ON) the Foot brake is released
The foot brake is cocked
ОВ
The pressure close to pressure of the battery
Check up electroconducting Replace the gauge-switch of stoplights
63 + 1 Многофункцио¬нальный
The switch
Ignition is switched off (OFF)
Switch the selector lever in positions R, N, D, 2 and 3 Translate the selector lever in positions Р and 1 Switch the selector lever in positions Р, R, 2 and 1 Switch the selector lever in positions N, D and 3
It is opened Check up correctness of connection of conducting
Replace the multipurpose switch
0.8 - 1.0 Ohm
It is opened
40+1 0.8 - 1.0Ом
62 + 1   Ignition is switched off (OFF)
Switch the selector lever in positions Р, R, N and D Translate the selector lever in positions 3, 2 and 1
It is opened  
0.8 - 1.0 0м
18 + 1   Ignition is included (ON)
Switch the selector lever in positions Р, R and N
Switch the selector lever in positions D 3, 2 and 1
The pressure close to pressure of the battery  
ОВ
55 + 67 The electromagnetic valve 1 Ignition is switched off (OFF) the management Block is removed 55 - 65 Ohm Check up a condition of a plait of electroconducting
It is opened Replace the case клапанной assemblages
54 + 67 The elektromagnitknyj valve 2 Ignition is switched off (OFF) the management Block is removed 55 - 65 Ohm Check up a condition of a plait of electroconducting
54 + 1 It is opened Replace the case клапанной assemblages
9 + 67 The elektromagnitknyj valve 3 Ignition is switched off (OFF) ТСМ is disconnected 55 - 65 Ohm Check up correctness of connection of electroconducting
9 + 1 It is opened Replace клапанную assemblage
47 + 67 The elektromagnitknyj valve 4 Ignition is switched off (OFF) ТСМ is disconnected 4.5 - 6.5 Ohm Check up correctness of connection of electroconducting
47 + 1 It is opened Replace клапанную assemblage
56 + 67 The elektromagnitknyj valve 5 Ignition is switched off (OFF) ТСМ is disconnected 55 - 65 Ohm Check up correctness of connection of electroconducting
56 + 1 It is opened Replace клапанную assemblage
58 +22 The elektromagnitknyj valve 6 Ignition is switched off (OFF) ТСМ is disconnected 4.5 - 6.5 Ohm Check up correctness of connection of electroconducting
58+1/22+1 It is opened Replace клапанную assemblage
10 + 67 The elektromagnitknyj valve 7 Ignition is switched off (OFF) ТСМ is disconnected 55 - 65 Ohm Check up correctness of connection of electroconducting
10 + 1 It is opened Replace клапанную assemblage
23 + 29 Electromagnet th the gauge-switch of blocking of switching Ignition is switched off (OFF) ТСМ is disconnected 14 - 25 Ohm Check up correctness of connection of electroconducting Replace assemblage of an electromagnet of blocking of switching
1 + 16 The mode gauge-switch kickdown Ignition is switched off (OFF) ТСМ is disconnected a gas Pedal the gas Pedal completely is released squeezed out Than 1.5 Ohm is opened less Check up correctness of connection of electroconducting Adjust or replace a gas cable
20 + 65 The gauge of speed of movement of the car Ignition is switched off (OFF)
ТСМ is disconnected to Switch an ohmmeter to a limit of measurement 2 clod
800 - 900 Ohm Check up correctness of connection of electroconducting Replace the gauge of speed of the car
6 + 67 The gauge of temperature ATF Ignition is switched off (OFF)
ТСМ Is disconnected to Switch an ohmmeter to a limit of measurement 200 clod Temperature ATF = 20°С
24.700 Ohm Check up correctness of connection of electroconducting Replace клапанную assemblage
To switch an ohmmeter to a limit of measurement 200 clod Temperature ATF = 60°С Nearby 48.800 Ohm
Temperature ATF = 120°С Nearby 7400 Ohm
21 +66 The gauge of speed of movement (it is established on transmission) Ignition is switched off (OFF)
ТСМ is disconnected to Switch an ohmmeter to a measurement limit 2кОм
800 - 900 Ohm Check up correctness of connection of electroconducting Replace the gauge of speed of the car

Decoding of codes VAG of malfunctions of a control system by transmission

00258 Breakage, short circuit on weight or damage of an electromagnet 1
00260 Breakage, short circuit on weight or damage of an electromagnet 2
00262 Breakage, short circuit on weight or damage of an electromagnet 3
00264 Breakage, short circuit on weight or damage of an electromagnet 4
00266 Breakage, short circuit on weight or damage of an electromagnet 5
00268 Breakage, short circuit on weight or damage of an electromagnet 6
00270 Breakage, short circuit on weight or damage of an electromagnet 7
00281 Electroconducting breakage, is damaged the gauge of speed of the car or the wheel gauge
00293 Breakage of electroconducting or damage of the gauge-switch of a mode of transmission
00297 Breakage of electroconducting or damage of the gauge of speed
00300 Breakage of electroconducting or damage of the gauge of temperature ATF
00518 Breakage / short in electroconducting or damage of the gauge of position throttle заслонки (the signal of the gauge of position throttle заслонки arrives on ТСМ through ЕСМ;
On cars with CAN-tyre TSM checks only the fact of receipt of a signal from the gauge, on models without the CAN-tyre the condition of an alarm wire) is checked also
00529 Breakage of electroconducting or loss of a signal from the gauge of speed of the car, the gauge of speed of the car on transmission, turns of the engine or the gauge of position throttle заслонки
00532 Low voltage of a food of electromagnetic valves as a result of the battery category
00545 Breakage in electroconducting or short circuit on weight (communication between modules of engine management and transmission is broken)
00596 Short circuit in electroconducting of electromagnetic valves
00638 Breakage in electroconducting or short circuit on weight (communication between modules of engine management and transmission is broken)
00641 Excessively heat ATF or damage of the gauge of temperature ATF
00652 Refusal of functioning electricians or hydraulics (coupling or клапанная assemblage)
00660 Breakage of electroconducting or wrong connection of the gauge of position throttle заслонки (the gauge is damaged)
65535 It is faulty ТСМ

On the main page