Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
- 5. System of cooling, heating and ventilation
   5.1. A technical characteristics
   5.2. Removal and installation of hoses of system of cooling
   5.3. Removal, check and radiator installation
   5.4. Removal, check and thermostat installation
   5.5. Removal and installation of the water pump
   5.6. Check, removal and installation of the electric fan of a radiator
   + 5.7. Check, removal and installation of electric gauges of system of cooling
   5.8. Heating and ventilation system
   + 5.9. Elements of system of heating
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

5.3. Removal, check and radiator installation

The prevention

The radiator can be removed together with the radiator fan, but in connection with space restriction it is desirable to remove the radiator fan preliminary.


1. Merge cooling liquid from system of cooling and remove a wire of weight from the accumulator.
2. Loosen the collars also remove from a radiator the top and bottom hoses, and also a hose of a broad tank.
3. Disconnect two electric wires from a temperature-sensitive element of inclusion of the fan of the radiator located sideways of a radiator.
4. If the radiator fan is not removed yet, disconnect the electric socket close to the engine of the fan of a radiator. Release clips, fastening a plait of wires to a casing of the fan and move them aside.
5. On models with an automatic transmission disconnect and close suitable stoppers of a tube of the heat exchanger sideways a radiator.
6. Unscrew bolts of fastening of the radiator, located in the top corners of a radiator, and remove a radiator together with the radiator fan.


1. If the radiator acted in film in connection with throughput reduction, wash out its stream of water in two directions. Outside blow a radiator the compressed air.
2. If the radiator proceeds, do not try to make or solder a leaking place as plastic details of a radiator will be damaged. Insignificant негерметичность a radiator can be eliminated with use of hermetic of a radiator.
3. Check up a condition of the bottom rubber support of a radiator and, if necessary, replace them.


Installation is made in sequence, return to removal. In end fill in cooling liquid in cooling system, and on models with an automatic transmission check up oil level in a transmission and, if necessary, finish it to norm.

On the main page