Opel Kadett E

1984-1991 of release

Repair and car operation


Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
- 8. Ignition system
   - 8.1. System of ignition with the breaker
      8.1.1. A technical characteristics
      8.1.2. Check of system of ignition
      8.1.3. Adjustment of a backlash and the closed condition of contacts of the breaker
      8.1.4. Removal and installation of contacts of the breaker
      8.1.5. Check, removal and condenser installation
      + 8.1.6. The ignition distributor
      + 8.1.7. Adjustment of a corner of an advancing of ignition
      8.1.8. Removal, check and installation of the coil of ignition
   + 8.2. Electronic contactless system of ignition
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

8.1.4. Removal and installation of contacts of the breaker
THE GENERAL DATA

In the presence of dot corrosion or обгорания contacts it is necessary to replace them.

Removal

PERFORMANCE ORDER
1. Unscrew two screws and uncover the distributor of ignition and a rotor of the distributor of ignition a distributor shaft.
2. Move a spring of the lever of contacts of the breaker from a plastic insulator and disconnect a wire from contacts.
3. Unscrew the screw (it is specified by an arrow), крепящий a plate of the breaker of contacts to a basic plate of the distributor of ignition, and remove breaker contacts.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. Check up a backlash between contacts of the breaker or a corner of the closed condition of contacts of the breaker and, if necessary, adjust them.
3. Then establish a rotor of the distributor and a cover of the distributor of ignition.


On the main page