Opel Kadett E

1984-1991 of release

Repair and car operation


Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
- 8. Ignition system
   - 8.1. System of ignition with the breaker
      8.1.1. A technical characteristics
      8.1.2. Check of system of ignition
      8.1.3. Adjustment of a backlash and the closed condition of contacts of the breaker
      8.1.4. Removal and installation of contacts of the breaker
      8.1.5. Check, removal and condenser installation
      + 8.1.6. The ignition distributor
      - 8.1.7. Adjustment of a corner of an advancing of ignition
         8.1.7.1. The models using этилированный gasoline
         8.1.7.2. The models using Unleaded gasoline
      8.1.8. Removal, check and installation of the coil of ignition
   + 8.2. Electronic contactless system of ignition
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

8.1.7. Adjustment of a corner of an advancing of ignition

8.1.7.1. The models using этилированный gasoline
THE GENERAL DATA

For check and adjustment of a corner of an advancing of ignition it is necessary to use a stroboscope.

PERFORMANCE ORDER
1. Check up a backlash between contacts of the breaker or a corner of the closed condition of contacts of the breaker.
2. For adjustment of a corner of an advancing of ignition first of all clear adjusting labels on a pulley and a cover and note their white chalk or a quick-drying paint.
3. Start the engine and warm up it to normal working temperature, then switch off.
4. Connect the stroboscope gauge to a high-voltage wire of the first cylinder according to the stroboscope maintenance instruction.
5. Start the engine on turns of idling and direct a stroboscope on adjusting labels. Labels will seem motionless and if a corner of an advancing of ignition correct, they are combined.
6. If labels are not combined, ослабьте fastening of the distributor of ignition and, turning it in the parties, combine labels then tighten a bolt of fastening of the distributor of ignition.
7. Increase engine turns, thus adjusting labels should move from each other.
8. Switch off the engine and disconnect a stroboscope.


On the main page