1999-2003 of release
Repair and car operation
Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
- The operation manual
- Access, protection
Keys - the general information
The uniform lock (at a corresponding complete set)
The switch of ignition/lock of blocking of a steering column
System иммобилизации the engine
Luggage space cover (Legacy the Sedan)
Back door (Legacy the Versatile person and Outback)
The top hatches (at a corresponding complete set)
Access in подкапотное space
+ Elements of systems of safety
+ The car equipment, arrangement of devices and controls
+ Operation receptions
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Brake system
+ Suspension bracket and steering
+ Onboard electric equipment
System иммобилизации the engine
The device can enter into a standard complete set of anticreeping system of some models иммобилизации the engine (easier - иммобилизатор). The device serves for prevention of attempts of unapproved start of the engine and is effective anticreeping means, protecting the car from abduction.
In a head of keys of the models equipped with system иммобилизации of the engine, the microchip making switching-off иммобилизующего the engine of the antijoy ride device is built in.
The engine equipped иммобилизатором the car can be started only by means of the ignition key equipped with a built in microchip. In a microchip the special code is ciphered, and the anticreeping system makes blocking switching-off only in case of its identification. Attempt of start of the engine by means of any other key or a master key leads to switching-off of a chain of start of the engine.
The control lamp of an immobilizer is intended for the prevention of potential car thieves of presence on the car of corresponding anticreeping system. The lamp starts to blink approximately in 60 seconds after the ignition key will turn from position «ON» in position «АСС» or «LOCK», or is direct after key extraction. Refusal of activation of a lamp testifies to malfunctions in system иммобилизации.
At ignition inclusion (the ignition key will turn in position «ON») the control lamp of system иммобилизации lights up for some seconds, then dies away. The indicator blinking says that the system did not identify a key code. In this case it is necessary to switch off ignition (a key - in position «LOCK») to take out a key from the lock, then to repeat attempt.
If the system repeatedly refuses to identify a key code, address on car repair shop Subaru.
Do not undertake attempts to make any changes and additions in a design иммобилизатора. It can break normal functioning of electronic systems of the car and make its uncontrollable.
In case of loss of a key and impossibility of start of the engine, address on car repair shop Subaru.
Manufacturing of duplicates of the keys equipped with a built in microchip
For twirl manufacturing its identification number (see Has undressed Keys - the general information) is required. Before use any new key should be registered in system иммобилизации. Registration to four keys on one car is supposed.
From safety reasons at manufacturing of a new key codes of all other keys will be erased and re-registered. Therefore it is necessary to give in a workshop all keys from the car. Not re-registered keys cannot be used together with the re-registered. For the information on manufacturing of new keys and their registration with immobilizer system address on car repair shop Subaru.
On the main page