| 1. In regular intervals to turn out bolts of fastening of a flywheel on 1–2 turns. |
| 2. To turn out bolts and to remove a flywheel from a cranked shaft. At removal drive a disk it is necessary to note an arrangement of linings. |
| 3. To establish a flywheel or приводной a disk upside-down. Before installation to put on a carving of bolts hermetic. Bolts to tighten the moment 100 Н·м (10,0 кгс·м). If приводной a disk replaced, it is necessary to check up and if it is necessary to adjust its position. The distance from a back wall of the block of cylinders to an adjusting surface of the transformer on приводном a disk should be from 30,5 to 32,1 mm. To adjust position drive a disk it is possible, having established between it and cranked shaft a lining. |
|