Audi 100

1982-1990 of release

Repair and car operation




Audi 100
+ 1.1. Controls and devices
+ 2. Technical characteristics
- 3. Engines
   - 3.1. Four-cylinder engines
      3.1.1. Removal and engine installation
      - 3.1.2. Dismantling and engine assemblage
         3.1.2.1. Removal and installation of a head of the block of cylinders
         3.1.2.2. Removal of a camshaft and pushers of valves
         3.1.2.3. Camshaft survey
         3.1.2.4. Definition of a technical condition of hydropushers of valves
         3.1.2.5. Installation of a camshaft and pushers of valves
         3.1.2.6. Removal and installation of valves (dismantling of a head of the block)
         3.1.2.7. Survey, дефектовка and repair of details of a head of the block of cylinders
         3.1.2.8. Backlashes between cams of a cam-shaft and pushers of valves
         3.1.2.9. A camshaft drive
         3.1.2.10. Removal and installation of an intermediate shaft
         3.1.2.11. Removal and flywheel installation
         3.1.2.12. Replacement of epiploons of a cranked shaft
         3.1.2.13. Removal and installation oil картера
         3.1.2.14. Removal, check and installation of the oil pump
         3.1.2.15. Dismantling of shatunno-piston group
         3.1.2.16. Survey and check of details of shatunno-piston group
         3.1.2.17. Assemblage of shatunno-piston group
         3.1.2.18. Removal, survey and installation of a cranked shaft
   + 3.2. Five-cylinder engines
   + 3.3. The diesel engine
+ 4. Cooling system
+ 5. An exhaust system
+ 6. The power supply system
+ 7. Transmission
+ 8. A running gear
+ 9. A steering
+ 10. Brake system
+ 11. A body
+ 12. An electric equipment

3.1.2.14. Removal, check and installation of the oil pump
PERFORMANCE ORDER
1. To remove oil картер (subsection 3.1.2.13 subitem 1-5 see).
2. To turn away bolts of fastening and to remove the oil pump with маслоприемником.
3. To turn away two bolts and to uncover the pump.
4. To take out a shaft of a drive and a leading gear wheel of the pump.
5. To remove маслоприемник and to take out the mesh filter.
6. To wash out all details of the pump in gasoline.
7. To check up a backlash between teeths of gear wheels, as is shown in drawing at the left. The nominal backlash is equal 0,05 mm, maximum permissible – 0,2 mm. To check up a backlash between a gear wheel and the pump case, it should be equal 0,15 mm. To check up an axial backlash of gear wheels, as is shown in drawing on the right. It should be no more than 0,15 mm.
8. After replacement of defective details to grease all details of the pump with engine oil.
9. To collect and establish the pump upside-down.


On the main page