Audi 100

1982-1990 of release

Repair and car operation

3.1.2.2. Removal of a camshaft and pushers of valves

THE GENERAL DATA

Head of the block of cylinders, camshaft and valves

1 – the final valve; 2 – the inlet valve; 3 – a lining; 4 – a valve spring internal; 5 – a valve spring external; 6 – a plate of springs of the valve; 7 – a valve pusher; 8 – a washer adjusting; 9 – a camshaft; 10 – a bearing cover; 11 – шпонка;

12 – a camshaft cogwheel; 13 – a washer; 14 – a bolt of fastening of a cogwheel; 15 – valve crackers; 16 – маслосъемный a cap; 17 – a basic washer of springs of the valve; 18 – the directing plug of the valve; 19 – a head of the block of cylinders; 20 – an epiploon

PERFORMANCE ORDER

1. To turn away a bolt of fastening of a cogwheel of a camshaft, to remove a wheel 12 and to take from a nest on a shaft segment шпонку 11. 2. To turn away a nut of fastening of covers of bearings 1, 3 and 5th, considering from a belt of a drive of a camshaft. To mark covers and to remove them. 3. To weaken and in regular intervals to turn away a nut of fastening of covers of bearings of 2nd and 4th. To mark covers and to remove them. 4. To remove a camshaft together with an epiploon. 5. To mark and remove pushers of valves. At each pusher from above in dredging the adjusting washer 8 is established. From pushers it is not recommended to take out adjusting washers not to mix them at assemblage.