Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
- Brake system
Replacement of lobbies brake колодок
Removal and installation of disk brake mechanisms of back wheels
Check of a thickness of a brake disk
Removal and installation of a brake disk/support
Adjustment of a lay brake
Brake liquid
Removal of air from brake system
Removal and installation of a brake hose
Check of the amplifier of a brake
Removal, installation and adjustment of the switch of a stoplight
Removal and installation of the lever and cable of a lay brake
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes
|
Removal and installation of the lever and cable of a lay brake
The lever of a lay brake with fastening elements
1 – the lever of a lay brake
Before removal remove the central console.
2 – a lock washer
3 – facing of the lever of a lay brake. Acts in film forward
4 – a nut, 25 Н•м
5 – an adapter. For cars with the central armrest
6 – draught | 7 – the equalizer
8 – an adjusting nut
9 – a support finger
10 – a cable of a lay brake
11 – the switch of the control of a lay brake | CABLE REMOVAL Cars with a forward drive
| PERFORMANCE ORDER |
| 1. Remove the back central console, thus address to subsection Removal and pocket installation from outside the driver. | | 2. Release a lay brake. | | 3. Turn away an adjusting nut so that the cable could be removed from the equalizer. Disconnect a cable of a lay brake. | | 4. Disconnect a cable of a lay brake at a support, thus address to subsection Removal and installation of disk brake mechanisms of back wheels. | | 5. Mark a paint position of back wheels concerning naves. It will allow to establish at assemblage отбалансированное a wheel in its former position. Loosen the bolts of fastening of a wheel on the car standing on the earth. Lift a back part of the car, put it on supports and remove back wheels. | | 6. Disconnect a cable from the holder () at a beam of a back suspension bracket and remove from holders. |
| 7. Disconnect a cable from the holder () at a beam of a back suspension bracket and remove from holders | | 8. Take out a cable. |
| INSTALLATION
|
On the main page
|