Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
+ Forward suspension bracket
- Back suspension bracket
Removal and shock-absorber and spring installation
Removal and installation of the bearing of a wheel/knot of a nave
Shock-absorber check
Shock-absorber recycling
+ Steering
+ Body
+ Onboard electric equipment
+ Electroschemes
|
Removal and shock-absorber and spring installation
Cars with a forward drive REMOVAL
|
PERFORMANCE ORDER |
| 1. Mark a paint position of a corresponding back wheel concerning a nave. It will allow to establish at assemblage отбалансированное a wheel in its former position. Loosen the bolts of fastening of a wheel at the car standing on the earth. Lift a back part of the car, put it on supports and remove a back wheel. |
|
2. Bring sideways as a support under a back wheel the garage lift in a place where the wheel acts in film. A back suspension bracket do not lift. On an illustration lift V.A.G is shown. |
| 3. If it is necessary to remove only a spring, turn away a bolt – 2 fastenings of the shock-absorber to a beam. Completely unload a spring and take out it. For this purpose lower the lift. If necessary ask the assistant to pull a suspension bracket downwards. |
4. If it is necessary to remove also the shock-absorber, turn away fastening bolts
– 1 shock-absorber at a body also take out. |
|
INSTALLATION
|
PERFORMANCE ORDER |
|
1. Establish a spring so that the spring beginning (an arrow on an illustration) adjoined to an emphasis of the top basic ring. The top basic ring should sit correctly in a body. |
| 2. The beginning of a coil of a spring below should show necessarily to the car centre. |
| 3. Insert the shock-absorber and fix it below a new bolt and a new nut the moment 55 Н•м. |
| 4. Fix the shock-absorber to a body new bolts the moment 75 Н•м. |
|
|
On the main page
|