Audi A3

Since 1997 of release

Repair and car operation

Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
- The power supply system and release of the fulfilled gases
   - The power supply system
      Removal and installation of the fuel pump/gauge of a stock of fuel
      Removal and installation of the fuel filter
      Adjustment of a drive of gas
      Removal and installation of the case of the air filter
      Remote control connection by the fuel pump for carrying out of checks
      Check of the fuel pump
      Check of the relay of the fuel pump
   + System of injection of fuel
   + System of injection of the diesel engine
   + System of release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes

Adjustment of a drive of gas

THE GENERAL DATA

Gas drive. Engines 1.6, 1.8 l, except APY

1 drive of gas
2 stopper
3 pedal of gas
4 remote plug

5 plug of a support
6 washer
7 persistent screw
8 nut, 20 Н m

The petrol engine, except engine APY

ATTENTION

Cars with the diesel engine and model AUDI S3 (engine APY) have no gas drive. Position of a pedal of a brake is transferred to a control system of the gauge located on a pedal.
The gas drive is very sensitive to a break. Therefore at installation it is necessary to observe extra care. Insignificant demolition can lead to a drive exit out of operation in the course of car movement. The drives having damages, it is not necessary to establish.

PERFORMANCE ORDER

1. Press completely a pedal of gas and clamp it in this position or ask to make it the assistant.
2. Check up, whether throttle заслонки the lever adjoins to an emphasis of full gas. If necessary adjust a gas drive.

ADJUSTMENT

PERFORMANCE ORDER

	1. Take out a clamp (the marksman on an illustration).
2. Take out a drive at a support so that the lever throttle заслонки adjoined to an emphasis of full gas. In this position insert a clamp.
3. In addition for the car with АТ: Release a pedal of gas and again slowly move to a direction of full gas. On some distance against the stop full gas the switch kik-daun should work distinctly.

On the main page