Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
- Engine electric equipment
+ System of electronic control by ignition and injection
- Charge and start systems
The storage battery
Removal and installation of the storage battery
Check of the storage battery
The generator - the general data and security measures
Check of the established generator
Removal and generator installation
Check and replacement of brushes of the generator and pressure regulator
Starter - the general data
Check of system of start of the engine
Removal and starter installation
Check, removal and installation of the traction relay of a starter
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes
|
Check, removal and installation of the traction relay of a starter
In the presence of damages of the traction relay the starter gear wheel does not enter into a gear wreath of a flywheel. As a result of it the starter cannot start the engine. This malfunction meets more often, than malfunction of the engine of a starter.
Check without removal
|
PERFORMANCE ORDER |
| 1. The gear change lever establish in neutral position. | | 2. A check condition: the Storage battery should be charged. |
| 3. Connect накоротко the plug 30 (a thick positive cable) and 50 (a thin cable to the ignition lock) a starter. The starter gear wheel should come forward to (click) and the starter should be started. If it does not occur, remove a starter and check up it in the removed condition. |
|
Check with removal
| PERFORMANCE ORDER |
| 1. Remove a starter. |
2. Connect the storage battery an auxiliary cable (starting) as follows to a starter and the traction relay. A negative pole of the battery connect to the starter case. A cable from the positive plug of the battery put quickly to the plug 50 relays. The starter gear wheel should come forward.
ATTENTION
The positive cable should be attached to the plug 50 during time no more than 10 with, otherwise the relay winding will fuse.
|
| 3. If the gear wheel comes forward, and the starter does not rotate, it is necessary to hand over the starter electric motor in repair. |
| 4. If the gear wheel does not come forward, replace the traction relay. | | REMOVAL |
PERFORMANCE ORDER |
| 1. Remove a starter. |
| 2. Turn away 2 bolts of fastening of the traction relay. | | 3. Disconnect and remove the traction relay from a starter. | | INSTALLATION |
PERFORMANCE ORDER |
| 1. Cover a contact plane (F) a starter with corresponding hermetic. |
| 2. Connect the traction relay to the drive lever in a starter, then fix nuts. | | 3. Connect a wire to the traction relay. | | 4. Again check up the traction relay as it is described above. | | 5. Establish a starter into place. | | |
|
|
On the main page
|