Citroen Xantia

Since 1993 of release

Repair and car operation

Citroen Xantia
+ Introduction
+ The operation manual
- Routine maintenance
   + Weekly checks
   + Car routine maintenance - petrol models
   - Car routine maintenance - diesel models
      Regular service
      Replacement of impellent oil and the oil filter
      Check of a condition of hoses, and revealing of sources of leaks
      Removal of water from the fuel filter
      Check of adjustment of coupling
      Check of level ATF
      Suspension bracket and steering drive
      Check of a condition of protective covers of power shafts
      Reading of memory of the block of self-diagnostics
      Replacement of the dust removal filter (model with К/В)
      Check of a condition of a coolant of a central air of air
      Check and adjustment of turns of idling and prevention spontaneous останова the engine
      Check of serviceability of functioning of systems of decrease in toxicity of the fulfilled gases
      Check of a condition and replacement of a belt of a drive of auxiliary units
      Greasing of the mechanism of a drive of deenergizing of coupling
      Check of serviceability of functioning and adjustment of a lay brake
      Trial runs
      Replacement of the fuel filter
      Replacement трансмиссионной liquids АТ
      Condition check колодок brake mechanisms of forward and back wheels
      Greasing of locks and loops
      Replacement of hydraulic liquid LHM and the returnable filter
      Replacement of a filtering element of an air cleaner
      Level check трансмиссионного oils (models with РКПП)
      Check of a condition of brake supports, disks and hydraulic hoses
      Replacement of a belt of drive ГРМ
      Replacement of a cooling liquid
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Check of level ATF



1. Make on the car a short trip, having warmed up transmission to normal working temperature. Be parked on an equal horizontal platform, whenever possible with a firm covering. Level check трансмиссионной liquids is made by means of special measuring probeа, the impellent compartment located in a forward part, directly ahead of the engine block. The handle top probeа for simplification of searches is usually painted in bright colour.

2. Leave the engine working on single turns and translate selector AT lever in position “Р”. Take probe from a directing tube and dry wipe its edge pure rags or a paper towel. Fill probe back, having planted it in a tube against the stop, then again take. On size of the moistened site of an edge define level ATF, - it should be between the top and bottom marks probeа.

3. In case of need make corresponding updating, having added demanded quantity of a liquid through directing tube probeа. For convenience take advantage of a funnel.

Watch, that level ATF did not rise above the top mark.

4. Having finished updating, make on the car a short trip for the purpose of distribution ATF on surfaces of internal components of transmission, then repeat level check. In case of need add missing quantity of a liquid.
5. Watch, that liquid level constantly was in transmission between the bottom and top marks in an edge measuring probeа. Remember that lack ATF can lead to serious internal damages of transmission.
6. Necessity of frequent performance of updating of level ATF testifies to development of the leaks which source should be immediately revealed, and the reason is eliminated.

On the main page