Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   - Start and charge systems
      Diagnostics of malfunctions of an electric equipment
      Check of a condition and battery gymnastics
      Removal and installation of the storage battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of a drive of the generator
      Removal and generator installation
      Dismantling and generator assemblage, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and starter installation
      Check of serviceability of functioning and starter repair
      Removal and installation of the switch of ignition
      Removal and installation of the gauge-switch of a control lamp of pressure of oil
      Removal and installation of the gauge of level of impellent oil
      Removal and installation of the gauge of temperature of impellent oil
   + Ignition system - petrol models
   + Preheat system - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of the gauge-switch of a control lamp of pressure of oil

Removal

 PERFORMANCE ORDER

1. The Gauge-switch is established in a lobby of the block of cylinders, over a support of the oil filter. For the purpose of providing of access to the gauge-switch firmly cock a lay brake, then поддомкратьте redock of the car and establish it on props.
2. Disconnect a negative wire from the battery.
3. At a corresponding complete set remove protective муфту with штекерного a socket, then disconnect from the gauge-switch electroconducting.
4. Turn out the gauge-switch from the block of cylinders and remove a sealing washer. Prepare for gathering of spilt oil. An aperture at once закупорьте in order to avoid hit in the dirt engine.

Installation

 PERFORMANCE ORDER

1. Check up a condition of a sealing washer. In case of revealing of defects make replacement.
2. Screw the gauge-switch with a washer on the regular place and tighten it with demanded effort. Restore initial connection of electroconducting.
3. If lifted, lower the car on the earth, then check up level of impellent oil. In case of need make corresponding updating (address to the Head Routine maintenance).



On the main page