Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   - Start and charge systems
      Diagnostics of malfunctions of an electric equipment
      Check of a condition and battery gymnastics
      Removal and installation of the storage battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of a drive of the generator
      Removal and generator installation
      Dismantling and generator assemblage, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and starter installation
      Check of serviceability of functioning and starter repair
      Removal and installation of the switch of ignition
      Removal and installation of the gauge-switch of a control lamp of pressure of oil
      Removal and installation of the gauge of level of impellent oil
      Removal and installation of the gauge of temperature of impellent oil
   + Ignition system - petrol models
   + Preheat system - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and starter installation

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Prop up противооткатными boots back wheels. Firmly cock a lay brake, then поддомкратьте redock of the car and establish it on props. In case of need remove an air cleaner casing (see the Head of the Power supply system and release).

3. Release two fixing nuts and disconnect electroconducting from the traction relay of a starter. Remove the washers established under nuts.

4. Supporting starter assemblage, turn out three fixing bolts. Remove washers. Try to remember position of arms of fastening of hoses and electroconducting.

5. Take a starter from under the engine. Remove directing pin ().

Installation

Installation is made upside-down. Do not forget to establish into place directing pin () and arms of fastening of hoses/electroconductings. Strongly tighten fixture.

On the main page