Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
- Engine electric equipment
   - Start and charge systems
      Diagnostics of malfunctions of an electric equipment
      Check of a condition and battery gymnastics
      Removal and installation of the storage battery
      Check of serviceability of functioning of system of a charge
      Removal, installation and adjustment of a tension of a belt of a drive of the generator
      Removal and generator installation
      Dismantling and generator assemblage, check of a condition of internal components
      Check of serviceability of functioning of components of system of start
      Removal and starter installation
      Check of serviceability of functioning and starter repair
      Removal and installation of the switch of ignition
      Removal and installation of the gauge-switch of a control lamp of pressure of oil
      Removal and installation of the gauge of level of impellent oil
      Removal and installation of the gauge of temperature of impellent oil
   + Ignition system - petrol models
   + Preheat system - diesel models
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of the gauge of temperature of impellent oil

Removal

The gauge will screw in a forward part of the pallet of a crater of the engine.

 PERFORMANCE ORDER

1. For the purpose of providing of access to the gauge prop up противооткатными boots back wheels, then поддомкратьте redock of the car and establish it on props.
2. Merge impellent oil in pure capacity, screw into place a drain stopper and tighten it with demanded effort (address to the Head Routine maintenance).
3. Disconnect electroconducting, then turn out the gauge from the pallet картера and remove together with a sealing washer.

Installation

 PERFORMANCE ORDER

1. Check up a condition ears, in case of need make replacement.
2. Screw the gauge on the regular place and carefully tighten. Connect electroconducting.
3. Lower the car on the earth and fill in in the engine engine oil (address to the Head Routine maintenance).



On the main page