Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
- Transmission
   - Manual box of a gear change
      Replacement трансмиссионного oils
      Drive of the mechanism of a gear change - the general information and adjustment
      Removal and installation of components of a drive of a gear change
      Replacement of epiploons
      Check of serviceability of functioning, removal and installation of the gauge-switch of fires of a backing
      Removal and installation of a drive of a speedometer
      Removal and transmission installation
      Major repairs РКПП - the general information
   + Automatic transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of components of a drive of a gear change

Removal

 PERFORMANCE ORDER

1. Prop up противооткатными boots back wheels, then поддомкратьте redock of the car and establish it on props.
2. Give a nut and take an axial bolt of fastening of draught of a gear change to the basis of the lever of switching.

3. Accurately having hooked a screw-driver, liberate three draughts from the spherical hinges on transmission. Disconnect draught of switching from an axis of the cranked lever and take it from under the car.

4. Remove a plastic protective cap from a bolt of fastening of the cranked lever to a stretcher.
5. Turn out an axial bolt of the cranked lever and take it together with a washer. Remove the cranked lever with connecting draught (a switching rod) and take assemblage from under the car. Remove remote and axial plugs from the central part of the cranked lever.
6. Check up all components of a drive on presence of signs of deterioration and mechanical damages. It is necessary to give special attention to a condition of axial plugs and spherical hinges of draughts. Replace the defective and worn out components. In case of need make dismantle of the lever of a gear change (see further).

7. Liberate a protective cover of the lever from the panel of the central console.

8. Then turn off the handle and remove a cover from the lever.

9. Give fixing nuts, remove a fixing plate, lower downwards the lever of a choice and take it from under the car.
10. Delay from the basis of the lever of switching the bottom protective cover, then disconnect a fixing plate of the lever and lift the top protective cover, having provided with that access to the rotary hinge of lever assemblage. Check up assemblage components on presence of signs of deterioration and mechanical damages, estimate a condition of protective covers, replace defective details. In case of need the lever can be separated from the basis after removal of a lock ring.

Installation

Installation is made upside-down. Pay attention to following moments:
   a) Before installation check up correctness of installation of length of draughts of a drive of a gear change, in case of need make corresponding updating (the Drive of the mechanism of a gear change - the general information and adjustment see);
   b) do not forget to grease with special structure (Specifications see) the rotary hinge of the lever of switching, and also spherical hinges of draughts of a drive and axial plugs of the cranked lever;
   c) Track correctness of landing and reliability of fixing of protective covers of the lever of switching;
   d) Track observance of demanded efforts of a tightening of axial bolts of the cranked lever and the choice lever, check up reliability of a joint of spherical hinges.


On the main page