Citroen Xantia

1. Prop up противооткатными boots back wheels, then поддомкратьте redock of the car and establish it on props. The speedometer drive is located in a back part of a transmission, near to an input point in differential of the right power shaft. Depending on a complete set of model the drive can have mechanical (тросовую) a design, or is the electronic gauge.
2. On models with тросовым a speedometer drive take a fixing finger and disconnect a cable from приводной gear wheels. On other models disconnect corresponding electroconducting.

3. Turn out a fixing bolt and remove it together a thermofilter (if that is provided).

4. Take приводную assemblage with a conducted gear wheel from картера РКПП and remove it together with a sealing ring.

5. In case of need the gear wheel can be taken from картера transmissions (do not forget to remove an epiploon) check up a gear wheel condition, in case of revealing of mechanical defects make replacement. Without fail replace a sealing ring.
6. In case of revealing of signs of deterioration or damage of a conducted gear wheel it is necessary to check up also a condition of a leading gear wheel.

7. For extraction of a leading gear wheel liberate from transmission the right power shaft (subsections "Epiploons of power shafts" and "the Right power shaft" in section Replacement of epiploons see). Turn out three fixing bolts and remove a casing of a leading gear wheel of a drive of a speedometer with картера РКПП (together with a sealing ring). Take conducting приводную a gear wheel from differential assemblage, remove all adjusting washers.

1. Establish in differential adjusting washers, then get on the regular place a leading gear wheel of a drive of a speedometer, having tracked correctness of its input in gearing with reciprocal grooves. Establish a new sealing ring on the back party of a casing приводной assemblages. Establish a casing on transmission and strongly tighten fixing bolts. Estimate degree of deterioration of an epiploon of a power shaft, in case of need make replacement. Fill in transmission a power shaft (Replacement of epiploons see).

2. Slightly grease with dense greasing of a sponge of a new epiploon and a pin of an axis of a conducted gear wheel. Plant an epiploon in assemblage of a drive of a speedometer.
3. Establish a new sealing ring and fill приводную assemblage on the regular place, having tracked correctness of introduction of gear wheels in gearing.
4. Screw a fixing bolt (at a corresponding complete set do not forget about a thermofilter) and strongly tighten it.
5. On models with an electric speedometer restore initial connection of electroconducting. On models with тросовым a drive connect a cable, greasing where it is required sealing rings. Fix rubber a cable a cylindrical pin (finger).
6. Lower the car on the earth.