Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
+ 3.1. 4-cylinder engines
- 3.2. Engines V6 of 3,0 l (1993-1994) and 3,4 l (since 1995)
3.2.1. Specifications
3.2.2. Repair kinds, выполняемыe without removal of the engine from the car
3.2.3. Installation of the piston of 1st cylinder in ВМТ a compression step
3.2.4. Covers of heads of cylinders
3.2.5. A soaking up collector
3.2.6. Final collectors
3.2.7. A belt of an asterisk of cam-shafts
3.2.8. A forward epiploon коленвала
3.2.9. Epiploons of cam-shafts
3.2.10. Cam-shafts and pushers
3.2.11. Heads of cylinders
3.2.12. The oil pallet
3.2.13. The oil pump
3.2.14. A flywheel (a leading disk of the hydrotransformer)
3.2.15. A back epiploon коленвала
3.2.16. Engine mount details
+ 3.3. Dismantle and engine major repairs
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes
|
Removal
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight. |
| 2. Remove the levelling chamber (subsection 5.11.5 see). This procedure difficult enough, therefore attentively familiarise with instructions in the present management, designate all hoses and wires. |
| 3. Remove from wire candles. |
| 4. Designate and disconnect from a cover all hoses and wires and take aside. |
|
|
| 5. Turn away bolts of covers of heads of cylinders. In drawing 11 bolts of covers of heads of cylinders of the engine of 3,0 l, in drawing on the right – bolts of covers of heads of cylinders of the engine of 3,4 l at the left are represented. |
| 6. Remove covers. If the cover does not give in, displace its blows of a hammer through the soft prorate, or cautiously open consolidation шпателем. |
|
Installation
| PERFORMANCE ORDER |
| 1. Carefully clear condensed surfaces of a cover and a head of cylinders, remove oil traces. |
|
2. Put hermetic on semicircular заглушки and establish them on a head of cylinders, put hermetic on flat sites заглушек. Places of drawing of hermetic on engines of 3,0 l are designated (1).
|
| |
3. Put hermetic on semicircular заглушки and establish them on a head of cylinders, put hermetic on flat sites заглушек. Places of drawing of hermetic on the engine of 3,4 l are designated by shading. |
| 4. Lay on a cover a new lining, establish a cover, sealing washers and wrap nuts. On the engine of 3,4 l replace уплотнители casings candles. |
| 5. In regular intervals tighten bolts of a cover with the set moment in 3-4 stages. |
| 6. Establish other details, start the engine and be convinced of absence of a leak. |
|
|
On the main page
|