Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
+ Forward suspension bracket
+ Back suspension bracket
- Steering
Removal and installation of the block of a pillow of safety
Removal and steering wheel installation
Removal and installation of steering draught/tip of steering draught
Removal and installation of the pump of the hydraulic booster of a wheel
Corners of installation of forward wheels
+ Body
+ Onboard electric equipment
+ Electroschemes
|
Removal and installation of the block of a pillow of safety
ATTENTION Before removal of the block a safety pillow necessarily accept corresponding security measures.
|
PERFORMANCE ORDER |
1. Disconnect a negative cable (-) the storage battery at the switched off ignition.
ATTENTION Thereof the information from electronic blocks of memory, as for example, a radio receiver code is erased. Without a code the radio receiver can be included only the manufacturer or HUNDRED AUDI. Therefore familiarise with instructions in subsection Removal and installation of the storage battery and subsection Input of a code of a radio receiver.
|
| 2. Isolate a negative pole (-) the storage battery thereby to exclude casual contact. |
| 3. Establish wheels directly, and a steering wheel in average position. |
|
4. Turn out two screws Torx of fastening of the block of a pillow of safety key Т30. |
| 5. Расстыкуйте a socket of the block of a pillow of safety. |
| 6. Remove the block and put towards the soft party upwards. |
| 7. Do not change position of a steering column (direct position of wheels). |
|
INSTALLATION
|
PERFORMANCE ORDER |
| 1. Join a socket of a pillow of safety. |
| 2. Establish a safety pillow on a steering wheel and fix the moment 7 Н•м. |
3. Include ignition, the ignition key should be in position "Movement".
ATTENTION During connection of the storage battery do not leave people in car salon.
|
4. Attach a weight cable (-) the storage battery.
ATTENTION Make active automatics electric window lifterа, and also establish hours, being guided by subsections Removal and installation of the storage battery and Input of a code of a radio receiver.
|
|
|
On the main page
|