Audi A3

Since 1997 of release

Repair and car operation

Input of a code of a radio receiver

THE GENERAL DATA

(Really only concerning radio receivers with the coding)

Sign of a radio receiver with the coding is presence of a red symbol in the form of a key on a forward overlay. If at the taken out ignition key on the forward party the red light diode blinks, it means that the coding is made active also a radio receiver is ready to work.

The code interferes with unapproved inclusion of a radio receiver if its food has been interrupted. The termination of a food of a radio receiver occurs, for example, at its removal, switching-off from the storage battery or at перегорании a safety lock.

If the radio receiver is coded, it is necessary before switching-off of the storage battery or radio receiver removal to establish a radio receiver code. If the code is not known, include a radio receiver can only HUNDRED AUDI.

The individual code code number is resulted in the radio receiver operation manual. It is not necessary to store it in the car.

Removal of electronic blocking

PERFORMANCE ORDER

1. Include a food, include a radio receiver.
2. Press simultaneously keys «FM» and «DX» until on indication not to appear the message «CODE». Release keys, soon after that the message «1000» is automatically displayed. ATTENTION At a radio receiver «chorus» and «concert» instead of keys «FM» and «DX» keys «ТР» and «RDS» are pressed.
3. By means of keys of a choice of stations with 1 on 4 enter a confidential code. Thus the key 1 enters the first place of number of a code, a key 2 the second place etc. the Key press the number of times corresponding to figure of a code.
4. Then again press simultaneously keys «FM» and «DX» until there will be a message «SAFE». Release keys. Now the radio receiver is again ready to work. Frequency is automatically displayed. ATTENTION If the incorrect code the message „SAFE“ at first blinks is wrongly entered, and then shone constantly. Now all process of input can be repeated once again. If the incorrect code again is entered, the radio receiver is blocked approximately at 1 o'clock. After the expiration of 1 hour - the radio receiver thus should remain included - blocking acts in film. The input cycle repeats at the subsequent attempts.

Cars of release since 8/98, equipped with radio receivers „beta“ and „gamma“

After joining of a radio receiver to the power supply there is an automatic data exchange between a radio receiver and the block of the panel of devices. The code which has been written down at the first activization of protection against thefts is thus compared. At conformity of a code the radio receiver is ready for operation.

The radio receiver is blocked, if it is established in other car or if the block of the panel of devices is replaced. In this case it is necessary to remove blocking by code introduction.

On the main page