|
Citroen XantiaSince 1993 of releaseRepair and car operation |
|
Citroen Xantia + Introduction + The operation manual + Routine maintenance + Engine repair - Systems of cooling, heating Detachment and replacement of hoses of system of cooling Removal, check of a condition and radiator installation Removal, check of serviceability of functioning and thermostat installation Check of serviceability of functioning, removal and fan installation (ов) cooling systems Check of serviceability of functioning, removal and installation of electric switches and gauges of system of cooling Removal and installation of the water pump Removal and installation of a casing of the thermostat / the fuel filter (diesel models) System of heating/ventilation of salon - the general information Removal and installation of components of system of heating/ventilation of salon Air central air - the general information and safety measures Removal and installation of components of a central air of air + The power supply system and release + Engine electric equipment + Coupling + Transmission + Power shafts + Uniform hydraulic system + Brake system + Running gear and steering + Body and salon furnish + Onboard electric equipment + Electric equipment schemes |
Чип-тюнинг Тойота в Саратове смотрите на http://www.nocheck.ru. Этот улов мне пришлось продать тут же на пляже ну некуда было девать проститутку минска снять. Air central air - the general information and safety measures The general information Air central air (К/В) enters into a standard complete set of all models of a representation class, and also, as an additional complete set, can be established on any other models. The system allows to lower temperature of air submitted to salon, and also to make its drainage that appreciably raises comfort of stay in the car of the driver and passengers. In a mode of cooling К/В the household refrigerator works by the same principle, as. The gaseous coolant is soaked up in the compressor working from a belt drive, then arrives in the condenser established before a radiator where gives the heat, passing in a liquid phase. Further, the liquid coolant through the broad valve arrives in the evaporator where from a liquid being under a high pressure turns to the rarefied gas. The given phase transition is accompanied by sharp temperature drop and, accordingly, evaporator cooling. Then the coolant comes back in the compressor and a cycle repeats. Air blown through the evaporator is cooled and arrives in assemblage воздухораспределителя where by mixing with the hot air arriving from the heat exchanger of a heater, the temperature set for choice the operator is given to it. The received mix of air of the demanded temperature moves in car salon. In case of need heating of air in salon the system works as a usual heater on models of a standard complete set (the System of heating/ventilation of salon - the general information see). Management of system is carried out by electronics of the block of management BITRON which is carrying out the control over functioning of the electric fan (ов) of system of cooling, compressor K/V and built in in the panel of devices of a control lamp. In case of infringement of serviceability of functioning of system it is necessary to address in a special workshop or firm service-centre of company Citroyon. Safety measures At service of any components of a refrigerator path of a central air of air it is necessary to observe special safety measures. The same concerns the procedures connected with necessity рассоединения of lines of a refrigerator path.
|
On the main page
|