Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
- Systems of cooling, heating
   Detachment and replacement of hoses of system of cooling
   Removal, check of a condition and radiator installation
   Removal, check of serviceability of functioning and thermostat installation
   Check of serviceability of functioning, removal and fan installation (ов) cooling systems
   Check of serviceability of functioning, removal and installation of electric switches and gauges of system of cooling
   Removal and installation of the water pump
   Removal and installation of a casing of the thermostat / the fuel filter (diesel models)
   System of heating/ventilation of salon - the general information
   Removal and installation of components of system of heating/ventilation of salon
   Air central air - the general information and safety measures
   Removal and installation of components of a central air of air
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

System of heating/ventilation of salon - the general information

The heating/ventilation system consists of the fan placed in a casing, located in car salon behind the panel of devices, ventilating snuffled top level, lattices дефлекторов which are built in заподлицо in central and both lateral parts of the panel of devices of the car, and sleeves of giving of air in forward foot wells.

The control panel also is built in in the central part of the panel of devices of the car. Moving of control levers makes change of position corresponding заслонок for which account there is a deviation and mixing of streams of air arriving from various parts of system of heating/ventilation. Заслонки are located in a casing воздухораспределителя from which air warmed up to the demanded temperature moves in various points of salon.

Cold air is sucked in in system through a lattice established in a back part of an impellent compartment. The air stream, which force is defined by speed of rotation of the fan of a heater, on air lines arrives in various points of salon of the car depending on the chosen position of control levers. Stagnant air is deduced from salon through the air lines laid in a back part of the car. In case of need the heating, soaked up air, by moving of a corresponding control lever, goes to the heater heat exchanger, passing through which, heats up by selection of heat from a liquid of system of cooling of the engine.

In case of need giving in salon of external air can be completely blocked by a choice of a mode of the closed circulation. Such possibility allows to avoid hit in salon of badly smelling or strongly dusty air, however a mode should be used only quickly, owing to that air closed in small volume quickly stands.


On the main page