Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
- Systems of cooling, heating
Detachment and replacement of hoses of system of cooling
Removal, check of a condition and radiator installation
Removal, check of serviceability of functioning and thermostat installation
Check of serviceability of functioning, removal and fan installation (ов) cooling systems
Check of serviceability of functioning, removal and installation of electric switches and gauges of system of cooling
Removal and installation of the water pump
Removal and installation of a casing of the thermostat / the fuel filter (diesel models)
System of heating/ventilation of salon - the general information
Removal and installation of components of system of heating/ventilation of salon
Air central air - the general information and safety measures
Removal and installation of components of a central air of air
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes
|
Check of serviceability of functioning, removal and fan installation (ов) cooling systems
Check
Food giving on the fan () cooling systems is carried out through the ignition switch (the engine Electric equipment see the Head) and a safety lock (address to the Head the Onboard electric equipment). The thermosensitive gauge-switch of the fan enters Into a contour, on the majority of models established on a radiator also.
|
|
|
1. Warm up the engine to normal working temperature and leave its working on single turns. The fan should work directly ahead of that as the arrow of the index of temperature will reach the left border of a red range of a scale (before the control lamp will light up). In default the fan in the first always it is necessary to check up a condition of a corresponding safety lock. If the safety lock is perfectly in order, switch off ignition and disconnect electroconducting from the fan gauge-switch. Connect a crosspiece two contacts of an electric socket and again include ignition. If now the fan starts to function, it is necessary to replace the faulty gauge-switch. |
|
|
2. If the fan still does not work, make sure that on a gauge-switch socket a food of the battery (12) regularly moves. If a food is absent, check up a condition of corresponding electroconducting. Check up on presence of conductivity a chain site between the plug of grounding of the gauge-switch and weight. In case of need restore the lost contact.
3. If performance of all listed checks does not allow to reveal a fan cause of a failure, it is necessary to check up a condition drive the electromotor. Disunite an electric socket and submit a food from the battery directly on motor plugs. If the motor does not join, replace it in gathering. |
|
Removal
|
|
|
1. Disconnect a negative wire from the battery.
2. Remove a decorative lattice of a radiator (address to the Head the Body and salon furnish).
3. Disconnect the left hose of a radiator, then release clamps and incline radiator assemblage back (if necessary preliminary dismantle a coal adsorber — Removal, check of a condition and radiator installation see).
|
|
4. Working in space ahead of a radiator, give nuts of three bolts of fastening of the motor. |
|
|
5. Liberate electroconducting drive the motor from clamps on a fan casing.
6. Through кузовной an aperture under installation of a lattice of a radiator take the electromotor from an impellent compartment and disconnect from it electroconducting.
7. At desire крыльчатка can be removed from a shaft of the motor after отдавания the fixing screw/clamp. |
|
Installation
Installation is made upside-down. Remember that electroconducting should be connected to the motor before its installation on a fan casing.
In summary fill cooling system (address to the Head Routine maintenance).
|
On the main page
|