Citroen Xantia

1. Translate the lever in position “N” (Neutral).
2. For the purpose of providing of access to the end turned to transmission drive a cable remove the battery with the pallet and a basic plate (the engine Electric equipment see the Head). It is in addition possible to remove also an inlet air line () (see the Head of the Power supply system and release).
3. Having hooked the big screw-driver with a flat sting, accurately liberate a tip of a cable from the spherical hinge of the lever of a choice of transfers on transmission (keep the lever in the chosen position [N]).
4. Make sure that a tip will screw on a carving of the core of a cable not less than on 5 millimetres.
5. Make sure that the selector lever, no less than the lever of a choice of transfers on transmission, are in positions N. The cable tip should be combined in the correct image with the spherical hinge of the lever of a choice of transfers so that not to cause displacement of last at connection. In case of need make corresponding updating, rotating a cable tip in a demanded direction (do not forget about the condition stipulated in the previous point). If to achieve demanded result it is not possible, for the further adjustment ослабьте counternuts креп cable covers on its basic arm (drive a cable to a spherical support of the lever of a choice of transfers Fastening see transmission an illustration). Displace nuts in a demanded direction, achieving correct position of a tip. Do not forget to tighten a nut.
6. Having achieved satisfactory result, strongly fix a cable tip on the spherical hinge of the lever.
7. Establish into place all components acting in film for the purpose of providing of access.