Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
- Transmission
   + Manual box of a gear change
   - Automatic transmission
      Adjustment drive a cable of a choice of transfers АТ
      Removal and installation drive a cable of a choice of transfers АТ
      Removal and installation of assemblage of the lever of the selector of transfers
      Adjustment drive a cable of inclusion of a mode kick-down
      Replacement drive a cable of inclusion of a mode kick-down
      Removal and installation of a drive of a speedometer
      Replacement of epiploons
      Removal and installation of cooler ATF
      The gauge-switch of the permission of start/fires of a backing - the general information, removal and installation
      Removal and installation АТ
      Major repairs АТ - the general information
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Adjustment drive a cable of inclusion of a mode kick-down

 PERFORMANCE ORDER

1. Warm up the engine to normal working temperature and check up correctness of installation of turns of idling. In case of need make corresponding updating (see the Head of the Power supply system and release).

2. Disconnect the core drive a cable of inclusion of a mode kick-down from a cam of the case of a throttle, then check up correctness of adjustment of a cable of gas (see the Head of the Power supply system and release).

3. Extend the core of a cable from a cover till the moment of occurrence of resistance (inclusion of a mode testifying to the beginning kick-down) and measure distance from a back end face заделки () on a cable to a cut of its cover. The rating value makes about 39 mm. In case of need ослабьте two counternuts of fastening of a cover and in appropriate way correct position of last in an arm.

4. Connect a cable of inclusion of a mode kick-down to a cam of the case of a throttle, then check up again measure distance () between заделкой and a cover cut. At cam densely pressed to the emphasis the backlash () should make 0.5 mm, otherwise ослабьте counternuts of a cover and make corresponding updating.

5. Having finished adjustment, strongly tighten counternuts.


On the main page