Citroen Xantia

1. Cooler ATF is established from above on картере transmissions. For the purpose of providing of access to assemblage remove an inlet air line () (see the Head of the Power supply system and release). Turn out three bolts of fastening of a basic arm of hoses, separate an arm from assemblage of a cooler and shift it aside.
2. For the purpose of minimisation of losses of a cooling liquid by special clips or clamps press both coolers ATF of a hose brought to assemblage (see an illustration of the Detail of installation of cooler ATF).
3. Loosen the fixing collars also disconnect both coolers of a hose brought to assemblage. Prepare for gathering of a spilt cooling liquid. At once collect traces of the spilt liquid and rinse with cold water a cooler and surfaces adjoining to it.
4. Turn out the central bolt (see an illustration of the Detail of installation of cooler ATF). Also remove assemblage of a cooler about three. Remove from the central bolt the sealing ring put on it. Also remove two sealing rings, established in the basis of assemblage of a cooler. All three sealing rings are subject to replacement without fail.

1. Grease new sealing rings pure трансмиссионной with a liquid and establish them on the regular places on assemblage (Sealing rings of assemblage of cooler ATF see an illustration).
2. Establish cooler assemblage on the seat from above on картере АТ. Track, that the flat edge of assemblage has appeared located in parallel interfaced surface картера. Screw the central bolt and tighten it with demanded effort.
3. Connect to a cooler hoses охладительного a path, fix hoses collars and remove pressing clips/clamps.
4. Establish into place all components acting in film for the purpose of providing of access.
5. In summary add necessary quantity of a mix of demanded structure in system of cooling and check up level ATF (address to the Head "car Routine maintenance").