Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
- Transmission
   + Manual box of a gear change
   - Automatic transmission
      Adjustment drive a cable of a choice of transfers АТ
      Removal and installation drive a cable of a choice of transfers АТ
      Removal and installation of assemblage of the lever of the selector of transfers
      Adjustment drive a cable of inclusion of a mode kick-down
      Replacement drive a cable of inclusion of a mode kick-down
      Removal and installation of a drive of a speedometer
      Replacement of epiploons
      Removal and installation of cooler ATF
      The gauge-switch of the permission of start/fires of a backing - the general information, removal and installation
      Removal and installation АТ
      Major repairs АТ - the general information
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of assemblage of the lever of the selector of transfers

Removal

 PERFORMANCE ORDER

1. Prop up противооткатными boots back wheels, then поддомкратьте redock of the car and establish it on props. Translate the selector lever in position N.
2. Remove a thermofilter () systems of release of the fulfilled gases for the purpose of providing of access to the basis of assemblage of the lever of the selector (see the Head of the Power supply system and release).
3. Execute the procedures described in subsection "Removal", subitem 6-8, has undressed Removal and installation drive a cable of a choice of transfers АТ.
4. Under the car disconnect lever assemblage from the bottom of the car and lower it downwards.
5. Having hooked, remove from the basis of the lever and shift lengthways drive a cable a rubber protective cover.
6. Loosen the a nut of fastening of a cover of a cable also release a fixing clamp. Accurately separate a tip of a cable from the spherical hinge in the lever basis, then take assemblage of the last from under the car.

Installation

 PERFORMANCE ORDER

1. Execute the procedures described in in subsection "Installation", subitem 1-6, has undressed Removal and installation drive a cable of a choice of transfers АТ.
2. Establish into place a thermofilter () systems of release of the fulfilled gases (see the Head of the Power supply system and release), then lower the car on the earth.
3. In summary check up correctness of adjustment of a cable of a drive of a gear change, in case of need make corresponding updating (Adjustment drive a cable of a choice of transfers АТ see).


On the main page