Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
- 12. A suspension bracket and a steering
   12.1. A technical characteristics
   + 12.2. A rack of a forward suspension bracket
   12.3. Replacement of the bearing of a forward wheel
   + 12.4. The bottom lever of a forward suspension bracket
   12.5. Removal and installation of the forward stabilizer of cross-section stability
   12.6. Adjustment of the bearing of a back wheel
   + 12.7. A nave of a back wheel
   12.8. Replacement of the back shock-absorber
   + 12.9. The back stabilizer of cross-section stability
   12.10. Replacement of back springs
   12.11. Removal and installation of a back beam
   12.12. Replacement of the plug of the longitudinal lever of a back suspension bracket
   12.13. Replacement of elements of a back suspension bracket with sheet springs (Pickup)
   12.14. Check of system of a self-levelled back suspension bracket
   12.15. Removal and steering wheel installation
   + 12.16. A steering column
   12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition
   12.18. Removal and installation of tips of steering draught
   + 12.19. Steering transfer
   12.20. Removal of air from system of a steering with the amplifier
   12.21. Removal and installation of the pump of the amplifier of a steering
   12.22. Removal and installation пополнительного a tank of hydraulic system
   12.23. Corners of installation of forward wheels
+ 13. A body
+ 14. Electric schemes

12.5. Removal and installation of the forward stabilizer of cross-section stability

THE GENERAL DATA

The prevention
At installation it is necessary to use new nuts, fastening the stabilizer of cross-section stability to the bottom lever of a forward suspension bracket.

Removal

PERFORMANCE ORDER

1. Lift a forward part of the car and fix on supports.

2. Unscrew bolts, fastening the ends of the stabilizer of cross-section stability to the bottom levers.

3. Unscrew bolts of fastening of two arms of the stabilizer of cross-section stability.

4. Take the stabilizer of cross-section stability through one of wheel arches, if necessary turning a steering wheel.

5. If necessary replace adjusting plugs of the stabilizer of cross-section stability.

Installation

PERFORMANCE ORDER

1. Fix two arms of fastening of the stabilizer of cross-section stability, having tightened bolts of fastening by the demanded moment.

2. Tighten a bolt of fastening of the stabilizer to the bottom lever so that rubber pillows were compressed on certain size (And = 38 mm).

3. For fastening of the end of the stabilizer use new самоконтрящиеся nuts.

4. Lower the car on the earth.

On the main page