| 1. Remove forward section of the central console. |
| 2. Disconnect a cable of management from the case of distribution of air and remove the block of management of a heater. |
| 3. About a partition of a motor compartment press hoses of giving of a cooling liquid to a heater and disconnect them. |
|
|
| 4. Unscrew 4 screws, fastening a cover of the case of the distributor of air (in drawing unscrewing of the top screw of fastening at the left is shown). For access to the bottom screws (the bottom screw is shown by an arrow in drawing on the right) the carpet covering is necessary to turn on. |
| 5. Disconnect back air pipes of heating and uncover air distributor. |
|
6. Unscrew three screws, крепящих a heater radiator.
|
|
7. For access to the top screws it is necessary to move a folding shutter. The arrangement of the top screws of fastening of the fan of a heater is specified by arrows.
|
| 8. Remove a heater radiator. |
| 9. Installation is made in sequence, return to removal. Check up level of a cooling liquid and, if necessary, finish it to norm. |