Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
- 5. System of cooling, heating and ventilation
   5.1. A technical characteristics
   5.2. Removal and installation of hoses of system of cooling
   5.3. Removal, check and radiator installation
   5.4. Removal, check and thermostat installation
   5.5. Removal and installation of the water pump
   5.6. Check, removal and installation of the electric fan of a radiator
   + 5.7. Check, removal and installation of electric gauges of system of cooling
   5.8. Heating and ventilation system
   - 5.9. Elements of system of heating
      5.9.1. Removal and installation of the control panel by a heater
      5.9.2. Removal and installation of the engine of the fan of a heater
      5.9.3. Removal and installation of a radiator of a heater
      5.9.4. Removal and installation of the case of the distributor of air
      5.9.5. Removal and installation snuffled also lattices
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





5.9.4. Removal and installation of the case of the distributor of air
PERFORMANCE ORDER
1. Remove the engine of the fan of a heater and a heater radiator.
2. Unscrew five nuts, крепящих the panel of devices and an arm of pedals to a partition of a motor compartment.
3. Remove casings of a steering column. On models with an adjustable steering column also remove the button of a regulator and the bottom casing of a steering column.
4. Disconnect air lines which connect the case of the distributor of air to the panel of devices.
5. Unscrew remained two screws of fastening of the panel of devices, then move the panel of devices towards the passenger and remove the case of the distributor of air also towards the passenger.
6. Installation is made in sequence, return to removal. For fastening of the panel of devices and an arm of pedals use new самоконтрящиеся nuts.
7. Add cooling liquid in cooling system.

On the main page