Subaru Legacy/Outback

1. Tyre out the car on the lift.
2. Disconnect a negative wire from the battery.
3. Lift the car and remove forward wheels.
4. Turn out fixing bolts and disconnect from a beam a bar of the stabilizer of cross-section stability and домкратную a plate.
5. Disconnect from rotary fists tips of steering draughts.
6. Remove forward section of system of release of the fulfilled gases (see the Head of the Power supply system and release).
7. Give nuts of axial bolts of fastening to a beam of cross-section levers of a suspension bracket.
8. Separate cross-section levers from a beam of a suspension bracket and the car bottom (see Has undressed Removal, service and installation of cross-section levers of a forward suspension bracket).
9. Give fastening nuts to the cross-section lever of support of a suspension bracket of the power unit.
10. Hang out the power unit from above on лебедке, having raised it approximately on 10 mm.
11. Prop up a cross-section beam of a suspension bracket a jack, release fixing nuts, then slowly lower a beam in gathering with the steering mechanism, - track, that steering draughts were not hooked for covers of hinges of equal angular speeds (SHRUS).
12. Attentively examine a beam on presence of signs of excessive deterioration, cracks, deformations and other mechanical damages, in case of need make its replacement.
13. Installation is made upside-down. Track, that all fixture has been tightened with demanded effort.
14. In summary do not forget to remove air stoppers from a path of system of hydrostrengthening of a wheel.
15. Drive away the car on a car repair shop for check and adjustment of corners of installation of forward wheels.