Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   - 7.2. Coupling
      7.2.1. The main cylinder of coupling
      7.2.2. The working cylinder of coupling
      7.2.3. Coupling details
      7.2.4. The vyzhimnoj bearing
      7.2.5. The directing bearing
      7.2.6. A coupling hydrodrive
      7.2.7. A coupling pedal
      7.2.8. The blocking switch of coupling
   + 7.3. Карданный () a shaft () and карданные hinges
   7.4. Back and forward axes
   7.5. The bearing, an epiploon and полуось the back bridge
   7.6. An epiploon of a reducer of the back bridge and a forward axis
   7.7. The back bridge
   7.8. Forward semiaxes
   7.9. Replacement of covers and SHRUS dismantling
   + 7.10. An electromagnetic drive of a forward leading axis (ADD-system)
   7.11. A forward reducer
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

7.2.5. The directing bearing

Check and replacement

PERFORMANCE ORDER
1. The directing bearing is a support of a primary shaft of a check point and запрессован in an aperture in a back flange коленвала. A bearing condition it is necessary to check every time when coupling acts in film. If there are doubts concerning a bearing condition it is necessary to replace it. At removal of the engine the bearing varies without fail.
2. Remove a transmission.
3. Remove coupling.
4. Check up a bearing condition, having shined it in an aperture.
5. At detection of damages выпрессуйте the bearing.
6. In the absence of a stripper remove the bearing by means of hydroblow. For this purpose fill deepening in коленвале with dense greasing, carefully having removed air, and strike on оправке, inserted into the bearing. Diameter оправки should be a bit less than internal diameter of the bearing. Get the bearing and remove all greasing.
7. Запрессуйте the new bearing. The bearing epiploon should be turned outside.
8. Establish coupling and a transmission.


On the main page