Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system and release
   - The power supply system - petrol models
      Removal and installation of assemblage of an air cleaner
      Removal, installation and adjustment of a cable of gas
      Removal and installation of a pedal of gas
      Neetilirovannoe fuel - the general information and use rules
      Systems of injection of fuel - the general information
      Sbrasyvanie pressure in the power supply system
      Removal and installation of the fuel pump
      Removal and installation of the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Check of a condition and adjustment of system of injection of fuel
      Removal and installation of the case of a throttle
      Removal and installation of components of system Bosch Motronic 5.1
      Removal and installation of components of system Magneti-Marelli 8Р
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
   + The power supply system - diesel models
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of assemblage of an air cleaner

Removal

 PERFORMANCE ORDER

1. Loosen the a collar () also disconnect a ventilating hose () from the air sleeve connecting an air cleaner with the case of a throttle. Afterwards release fixing collars, disconnect an air sleeve from an air cleaner and remove it from the car. Where it is required, remove from the throttle case a rubber sealing ring.
2. Release two clamps, turn out two screws in a forward part of a cover of a head of cylinders and uncover an air cleaner a head of cylinders. Take filtering element.
3. For removal of an inlet air line give a bolt of fastening of its back section to an end face of a head of cylinders, then ослабьте a fixing collar and disconnect a sleeve from a cover of a head of cylinders. Turn out a bolt of fastening of forward section of an air line to a cross-section beam and take a sleeve from an impellent compartment.

Installation

Installation is made upside-down. Track correctness of connection and reliability of fastening of all hoses and sleeves.

On the main page