Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system and release
   - The power supply system - petrol models
      Removal and installation of assemblage of an air cleaner
      Removal, installation and adjustment of a cable of gas
      Removal and installation of a pedal of gas
      Neetilirovannoe fuel - the general information and use rules
      Systems of injection of fuel - the general information
      Sbrasyvanie pressure in the power supply system
      Removal and installation of the fuel pump
      Removal and installation of the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Check of a condition and adjustment of system of injection of fuel
      Removal and installation of the case of a throttle
      Removal and installation of components of system Bosch Motronic 5.1
      Removal and installation of components of system Magneti-Marelli 8Р
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
   + The power supply system - diesel models
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of a final collector

Removal

Models 1.6 and 1.8 l

 PERFORMANCE ORDER

1. Disconnect a hose of giving of hot air from the screen of a collector and remove it from the car.
2. Turn out three fixing screws and remove the screen from the top part of a final collector.
3. Prop up противооткатными boots back wheels, then поддомкратьте redock of the car and establish it on props.
4. In case of need disconnect electroconducting from the oxygen gauge (l-probe). Alternatively, prop up a reception pipe of system of release of the fulfilled gases in order to avoid a stretching of electroconducting of the gauge.
5. Give nuts of fastening of a reception pipe to a final collector. Turn out a bolt of fastening of a pipe to a basic arm. Separate a pipe from a collector flange, remove a lining.
6. Give eight nuts of fastening of a final collector to a head. Take a collector from an impellent compartment, remove a sealing lining.

L models 2.0

 PERFORMANCE ORDER

1. Prop up противооткатными boots back wheels, then поддомкратьте redock of the car and establish it on props.
2. Give two nuts of fastening of a reception pipe to a final collector. Remove springs with the cups, take bolts and separate a pipe from a collector flange. Remove a lining.
3. Give eight nuts of fastening of a final collector to a head. Take a collector from an impellent compartment, remove a sealing lining. Pay attention to the remote prorates established between a lining and the pipeline.

Installation

Installation is made upside-down. Pay attention to following moments:
   a) Check up a condition of hairpins of fastening of a collector, clean and restore a carving;
   b) Make sure of absoluteness of dryness and cleanliness of interfaced surfaces of a collector and a head of cylinders, check up their planeness. Do not forget to replace a lining (. All fixture should be tightened with demanded effort;
   c) Connection of a reception pipe of system of release of the fulfilled gases to a final flange of a collector make according to the instructions resulted in section of System of decrease of toxicity and release of fulfilled gases.

On the main page