Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
- 12. A suspension bracket and a steering
   12.1. A technical characteristics
   + 12.2. A rack of a forward suspension bracket
   12.3. Replacement of the bearing of a forward wheel
   + 12.4. The bottom lever of a forward suspension bracket
   12.5. Removal and installation of the forward stabilizer of cross-section stability
   12.6. Adjustment of the bearing of a back wheel
   - 12.7. A nave of a back wheel
      12.7.1. Removal and installation of a nave of a back wheel
      12.7.2. Replacement of bearings of a nave of a back wheel
   12.8. Replacement of the back shock-absorber
   + 12.9. The back stabilizer of cross-section stability
   12.10. Replacement of back springs
   12.11. Removal and installation of a back beam
   12.12. Replacement of the plug of the longitudinal lever of a back suspension bracket
   12.13. Replacement of elements of a back suspension bracket with sheet springs (Pickup)
   12.14. Check of system of a self-levelled back suspension bracket
   12.15. Removal and steering wheel installation
   + 12.16. A steering column
   12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition
   12.18. Removal and installation of tips of steering draught
   + 12.19. Steering transfer
   12.20. Removal of air from system of a steering with the amplifier
   12.21. Removal and installation of the pump of the amplifier of a steering
   12.22. Removal and installation пополнительного a tank of hydraulic system
   12.23. Corners of installation of forward wheels
+ 13. A body
+ 14. Electric schemes





12.7.2. Replacement of bearings of a nave of a back wheel MODELS TILL 1992

PERFORMANCE ORDER
1. Remove a nave.
2. From the interior of a nave remove a sealing ring and take an internal ring of the internal bearing.
3. Fix a nave in a vice with soft sponges and copper выколоткой beat out external rings of bearings from a nave. Thus выколотку establish in regular intervals on a circle in order to avoid a warp of bearings.

The prevention

At выбивании bearings be careful, that did not remain забоины on a bearing seat in a nave.


4. Clear a nest for the bearing in a nave and, using an emery paper, remove all agnails.
5. Establish new external rings of bearings cones outside. Using tubular оправку the corresponding diameter, запрессуйте rings of bearings in a nave. Thus be careful not to warp a ring as there can be their jamming and destruction.
6. Grease rings of bearings литиевой with greasing and the same greasing fill space between bearings.
7. Establish an internal ring of the internal bearing into place, grease a working edge of a new sealing ring and establish it into place with use tubular оправки the corresponding diameter.
8. Establish a nave and adjust люфт the nave bearing.

MODELS SINCE 1992

As the knot consisting of a fixing element of a nave, a nave and the nave bearing, is not folding, at deterioration of the bearing of a nave it is necessary to replace all knot.

On the main page