Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. 4-cylinder engines
      3.1.1. Specifications
      3.1.2. Repair kinds, выполняемыe without removal of the engine from the car
      3.1.3. Installation of the piston of 1st cylinder in ВМТ a compression step
      3.1.4. A cover of a head of cylinders
      3.1.5. A soaking up collector
      3.1.6. A final collector
      3.1.7. Cam-shafts and pushers
      3.1.8. A head of cylinders
      3.1.9. A cover of a chain drive of cam-shafts
      3.1.10. A forward epiploon коленвала
      3.1.11. The oil pallet
      3.1.12. The oil pump
      3.1.13. A flywheel (a leading disk of the hydrotransformer)
      3.1.14. A back epiploon коленвала
      3.1.15. Engine mount details
   + 3.2. Engines V6 of 3,0 l (1993-1994) and 3,4 l (since 1995)
   + 3.3. Dismantle and engine major repairs
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

3.1.15. Engine mount details

THE GENERAL DATA

Engine mount details as a rule do not demand leaving, however at detection of damage of support of the engine or their ageing, it is necessary to replace them immediately.

Check

PERFORMANCE ORDER

1. Lift the car and establish on supports, then place under the oil pallet of the engine a support. Lay between the pallet and a support the big board and cautiously raise the engine to unload support. It is forbidden to substitute a board under a drain stopper of the pallet.

2. Check up presence on support (are specified by arrows) cracks, hardening or отслоения from a metal basis.

3. Whether check up plates of support concerning the engine or a frame (for this purpose shake support mount, or the big screw-driver) move. If moving lower the engine is felt and tighten fastenings of support.

4. For ageing delay grease rubber details of support with preserving means.

Replacement

PERFORMANCE ORDER

1. Disconnect the battery from weight, lift the car and establish on supports.

2. Turn away a nut and bolts, raise the engine and remove a support.

3. Installation is carried out upside-down. Grease carvings of nuts and bolts with fixing structure and reliably tighten.

On the main page