Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. 4-cylinder engines
      3.1.1. Specifications
      3.1.2. Repair kinds, выполняемыe without removal of the engine from the car
      3.1.3. Installation of the piston of 1st cylinder in ВМТ a compression step
      3.1.4. A cover of a head of cylinders
      3.1.5. A soaking up collector
      3.1.6. A final collector
      3.1.7. Cam-shafts and pushers
      3.1.8. A head of cylinders
      3.1.9. A cover of a chain drive of cam-shafts
      3.1.10. A forward epiploon коленвала
      3.1.11. The oil pallet
      3.1.12. The oil pump
      3.1.13. A flywheel (a leading disk of the hydrotransformer)
      3.1.14. A back epiploon коленвала
      3.1.15. Engine mount details
   + 3.2. Engines V6 of 3,0 l (1993-1994) and 3,4 l (since 1995)
   + 3.3. Dismantle and engine major repairs
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

3.1.4. A cover of a head of cylinders


1. Disconnect the battery from weight (be convinced that radio tape recorder codes are known).
2. Remove an air inlet, disconnect from a cover ventilation hoses картера.
3. Remove заглушки candles, disconnect wires.
4. Disconnect cables and take aside. Remove a hook for engine posting.
5. Turn away bolts of a cover of a head of cylinders (are specified by arrows), uncover also a lining. If the cover does not give in, displace its blows of a hammer through the soft prorate, or cautiously open consolidation шпателем.


1. Carefully clear condensed surfaces of a cover and a head of cylinders, remove oil traces. Establish a new lining in a cover flute (the lining can to be changed if it has not hardened and on it there are no damages). Track safety of sealants of casings candles (are specified by arrows).
2. Put hermetic on semicircular заглушки and establish them on a head of cylinders.
3. Cautiously establish a cover and wrap bolts.
4. In regular intervals tighten bolts of a cover with the set moment.
5. Establish other details, start the engine and be convinced of absence of a leak.

On the main page