Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. 4-cylinder engines
      3.1.1. Specifications
      3.1.2. Repair kinds, выполняемыe without removal of the engine from the car
      3.1.3. Installation of the piston of 1st cylinder in ВМТ a compression step
      3.1.4. A cover of a head of cylinders
      3.1.5. A soaking up collector
      3.1.6. A final collector
      3.1.7. Cam-shafts and pushers
      3.1.8. A head of cylinders
      3.1.9. A cover of a chain drive of cam-shafts
      3.1.10. A forward epiploon коленвала
      3.1.11. The oil pallet
      3.1.12. The oil pump
      3.1.13. A flywheel (a leading disk of the hydrotransformer)
      3.1.14. A back epiploon коленвала
      3.1.15. Engine mount details
   + 3.2. Engines V6 of 3,0 l (1993-1994) and 3,4 l (since 1995)
   + 3.3. Dismantle and engine major repairs
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

3.1.5. A soaking up collector
THE GENERAL DATA
The prevention

If the collector is disconnected only for removal of a head of cylinders turn away bolts and take him aside, without disconnecting hoses and wires. Procedure of dismantle of a collector from the engine as separate detail is more low described.

Cнятие and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Execute декомпрессию fuel system (subsection 5.2 see).
3. Designate and disconnect hoses (subsection 5.4 see), a cable of a drive throttle заслонки (subsection 5.9 see) and remove the case заслонки (subsection 5.11.1 see) and the levelling chamber (subsection 5.11.5 see).
4. Remove a comb of the distributor of fuel and an atomizer (subsection 5.11.4 see).
5. Designate and disconnect hoses of the valve from recycling and from the modulating vacuum valve. Turn on from a collector a tube recycling.
6. Disconnect from a collector a wire on weight, turn away bolts and nuts (are specified by arrows) remove a collector (be preliminary convinced that the tube of a return gasoline pipe line is disconnected from a head of cylinders).
7. Clear a collector, check up a condition of a demountable plane, if necessary прошлифуйте.
8. Establish a new lining, establish a collector and wrap bolts and nuts.
9. Tighten bolts and nuts in regular intervals, with the set moment, being displaced from the centre to periphery.
10. Establish other details upside-down.
11. Before engine start check up smoothness of turn throttle заслонки.
12. Start the engine and be convinced of absence of a leak of a cooling liquid and tightness of vacuum connections.
13. Check up the car in road conditions.


On the main page