Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation



Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS-system
   8.3. Колодки disk brakes
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of back brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. A pressure regulator
   8.11. A manual brake
   8.12. Cables of a manual brake
   8.13. The vacuum amplifier of brakes
   8.14. Prorolling of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. The switch of a signal of braking
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes





8.15. Adjustment of a pedal of a brake
THE GENERAL DATA

Height of a pedal of a brake

1. The switch of a signal of braking


2. A pusher


3. Pedal height

PERFORMANCE ORDER
1. Check up distance of a pedal from a floor.
2. In need of adjustment disconnect a socket, turn away a counternut and remove the switch of a signal of braking.
3. Release a counternut of a pusher of the amplifier of brakes.
4. Rotating a pusher, adjust pedal height. Tighten a counternut.
5. Establish the switch of a signal of braking and adjust. For this purpose turn away the top nut so that плунжер the switch has adjoined to the pedal terminator. Wrap the top nut on 1 turn and check up necessity A.Pri's backlash establish a standard backlash and tighten a counternut. Attach a socket.
6. Check up fire of lamps of a signal of braking.
7. Check up a pedal free wheeling (1 – a pusher, 2 – a pedal free wheeling), i.e. distance from position of completely released pedal to a place in which resistance to its course starts to be felt. If the course does not correspond to norm repeat switch adjustment.
8. Check up height () the pressed pedal on the working engine.
9. If the height of the pressed pedal does not correspond to norm brakes are faulty (is available the leak).

On the main page