Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS-system
   8.3. Колодки disk brakes
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of back brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. A pressure regulator
   8.11. A manual brake
   8.12. Cables of a manual brake
   8.13. The vacuum amplifier of brakes
   8.14. Prorolling of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. The switch of a signal of braking
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

8.8. The main cylinder of brakes Removal and installation

PERFORMANCE ORDER

1. Substitute under the cylinder the pallet or spread rags.

2. Disconnect a socket from a tank.

3. Release the union of tubes on the main cylinder (it is recommended to release an alligator wrench). To the amplifier of brakes the cylinder fastens two nuts (are specified by arrows). Disconnect and muffle tubes.

4. Turn away 2 nuts of fastening of the cylinder to the vacuum amplifier and remove the cylinder.

5. Merge from a tank the liquid rests.

6. At installation fill the cylinder with a liquid, – this measure considerably reduces time of prorolling of brakes. Clamp the cylinder in a vice for a flange, fill in in a tank a liquid and press the piston big крестовой a screw-driver. At release the piston clamp fingers of an aperture of unions. Having pressed the piston some times, close apertures заглушками.

7. Establish the cylinder upside-down. Remove air from a hydrodrive.

On the main page