Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

8.5. A brake disk

THE GENERAL DATA

---

The prevention

Колодки vary only in the complete set on one axis. At clearing колодок a dust and a dirt to delete wiping by rags moistened in spirit or a special liquid, it is forbidden to blow.

---

Check and removal

PERFORMANCE ORDER

1. Release nuts of wheels, lift the car and establish on supports. Remove wheels and wrap nuts of wheels into place to fix a disk concerning a nave (to provide the appendix of effort to a disk it is possible to dress washers). 2. Remove a support and take aside. 3. Check up a condition of a disk from both parties. At detection of traces of deep development (depth more than 0,38 mm) remove a disk and прошлифуйте. At detection of traces from rivets of overlays with disk surfaces as it is specified in drawing – a disk replace. 4. Check up palpation with the help стрелочного the indicator. If palpation on the indicator exceeds norm remove a disk and прошлифуйте. The prevention The disk in general is recommended to be removed and ground periodically on it is dependent on indicator indications. At least it can be made by hand a small skin to reduce a roughness. 5. After polishing the thickness of a disk should not be less maximum permissible which is cast on a disk. 6. After checks turn away wheel nuts and remove a disk.

Installation

Establish a disk and collect a brake upside-down. Lower the car.