Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS-system
   8.3. Колодки disk brakes
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of back brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. A pressure regulator
   8.11. A manual brake
   8.12. Cables of a manual brake
   8.13. The vacuum amplifier of brakes
   8.14. Prorolling of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. The switch of a signal of braking
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

8.3. Колодки disk brakes

The prevention

Колодки vary only in the complete set on one axis. At clearing колодок a dust and a dirt to delete wiping by rags moistened in spirit or a special liquid, it is forbidden to blow.

1. Release nuts of wheels, lift the car and establish on supports. Remove wheels.
2. Remove спринцовкой about 2/3 liquids from a tank (to exclude transfusion at cultivation колодок). Clear a support and adjoining details.
3. At removal колодок be guided by applied photos. Remove everyone колодку separately.
4. Clear details ториоза.
5. Get the bottom finger Pads.
6. Remove a spring колодок.
7. Get the top finger and remove external колодку.
8. Drown pistons of the external cylinder.
9. Grease with antinoise structure a basis Pads.
10. Establish antinoise overlays.
11. Grease overlays with antinoise structure, establish колодку, repeat all actions for internal Pads and collect a brake upside-down.
12. At dismantling check up a condition of covers of cylinders, a support and a disk, check up presence of traces of a leak of a liquid. In the presence of damages or a leak a support replace. If necessary remove a disk and прошлифуйте.
13. After assemblage fill a tank and press some times a brake pedal.

On the main page