Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS-system
   8.3. Колодки disk brakes
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of back brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. A pressure regulator
   8.11. A manual brake
   8.12. Cables of a manual brake
   8.13. The vacuum amplifier of brakes
   8.14. Prorolling of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. The switch of a signal of braking
+ 9. A suspension bracket and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

8.9. Hoses and hydrodrive tubes

The condition of hoses and tubes is recommended to check each 6 months.

Скоба union fastenings

1. A tube

2. Скоба

3. A hose

Check and replacement

1. Clear the union of a dirt.
2. Turn out the union of a tube from a hose and get скобу. Disconnect a hose from a support and remove.
3. Installation is carried out upside-down. At hose installation replace copper linings of the ring union. Arrange a hose so that it did not touch suspension bracket and steering details (the car at assemblage not to lift). Remove air from a hydrodrive.
4. At replacement of tubes track, that on all line they have been fixed by collars.
5. Installation only steel tubes, in accuracy corresponding to car mark is supposed.

On the main page