Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. A suspension bracket and a steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. The stabilizer of a forward suspension bracket
   9.4. A rotary fist
   9.5. A forward nave and the bearing
   9.6. Spherical support
   9.7. The top lever
   9.8. The bottom lever
   9.9. Back shock-absorbers
   9.10. The back stabilizer of cross-section stability
   9.11. A cross-section bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. A steering wheel
   9.15. A tip of steering draughts
   9.16. A cover of the steering mechanism
   9.17. The steering mechanism
   9.18. The hydraulic booster pump
   9.19. The wheel hydraulic booster
   9.20. Corners of installation of forward wheels
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

9.13. Longitudinal bars of the back bridge Removal and installation

1. Lift a back part of the car.
2. Establish supports under a bridge beam.
3. Disconnect from bars conducting of gauges of speed.
4. For removal of the top bar turn away a nut (are specified by arrows), remove washers and fastening bolts to a frame and to the bridge.
5. For removal of the bottom bar turn away a nut, remove washers and fastening bolts to arms on a frame and the bridge.
6. Check up a condition of plugs of bars.
7. At detection of damages of the plug replace (replacement is carried out in car-care centre).
8. Installation of bars is carried out upside-down.
9. Nuts of fastening of bars definitively tighten after car lowering.

On the main page