| 1. Lift redock of the car and remove wheels. |
|
2. Remove the gauge of speed (the arrow specifies a bolt). |
| 3. Remove a brake support. |
| 4. Remove a brake disk. |
|
|
| 5. Remove a brake board (at the left – bolts of a board of a brake on rear-wheel cars, on the right – bolts of a board of a brake on all-wheel drive cars). |
| 6. Disconnect from a fist a tip of steering draught. |
|
7. Расшплинтуйте also release корончатую a nut (not to turn on), then by means of a stripper выпрессуйте a finger of a spherical support from the top lever. |
|
8. Расшплинтуйте also release корончатую a nut (not to turn on) the bottom support (it is specified by an arrow). |
|
9. By means of a stripper выпрессуйте a finger of the bottom support. |
| 10. Disconnect a fist from levers of a suspension bracket and remove. |
| 11. Assemblage is carried out upside-down. |