Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation



Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. A suspension bracket and a steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. The stabilizer of a forward suspension bracket
   9.4. A rotary fist
   9.5. A forward nave and the bearing
   9.6. Spherical support
   9.7. The top lever
   9.8. The bottom lever
   9.9. Back shock-absorbers
   9.10. The back stabilizer of cross-section stability
   9.11. A cross-section bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. A steering wheel
   9.15. A tip of steering draughts
   9.16. A cover of the steering mechanism
   9.17. The steering mechanism
   9.18. The hydraulic booster pump
   9.19. The wheel hydraulic booster
   9.20. Corners of installation of forward wheels
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes





9.7. The top lever
THE GENERAL DATA

The top lever

1. Шплинт
2. The plug
3. The lever

Removal and installation
The prevention

Procedure concerns to zadne - and to all-wheel drive cars.


PERFORMANCE ORDER
1. Lift car redock.
2. Remove a support and take aside.
3. Disconnect wires from the gauge of speed (if there is an ABS-system).
4. Raise a jack the bottom lever of a suspension bracket. A jack not to clean.
5. Turn away a nut, remove a washer and an axis.
6. Check up a condition of plugs.
7. If plugs are damaged (cracks, deterioration) replace (replacement of plugs is carried out in car-care centre).
8. Assemblage is carried out upside-down.
9. Tighten a nut with the set moment.

The prevention

Nut to tighten only after car lowering, on an equal surface. It is possible to simulate also loading on the lever, having raised the bottom lever a jack.


10. On rear-wheel cars check up and adjust corners of installation of wheels.

On the main page